• 1982 Ducati TT2 - 1
  • 1982 Ducati TT2 - 2
1 / 14
1 / 14
Asking price

€19,900

Private seller

1982 Ducati TT2

  • Right Hand Drive
  • Manual, 5 speed
  • Petrol
  • 748cc
  • 1982
  • Red
  • Private seller
  • DE
    Freiburg im Breisgau, Germany

Description

Technical Specifications
Frame: Verlicchi tubular steel
Engine capacity: 748 cm³
Power: approx. 80 HP
Wheels: Marchesini magnesium 2. 5x18 front, 3. 5x18 rear
Front fork: Marzocchi 38 mm internals replaced with HH-Racetech cartridges
Rear shock absorber: Wilbers
Brakes: either Brembo P8 Oro 2-piston or Brembo P3034 4-piston, 280 mm fully floating brake discs. Brake master cylinder: either PS15 (round reservoir) or PR18 radial
Kerb weight: approx. 135 kg

For health reasons, we are parting with our beloved Ducati TT2 Racer.
We built the bike as a ‘nostalgia’ project (a mechanical engineer & a former Ducati mechanic), having previously competed together in the ‘Battle of the Twins’ with a Bevel Ducati back in the 1980s.
We bought the bike in 2014 from Thomas Bauer in Glauchau, who had raced it on a few occasions in East German hill climbs and once at the Sachsenring Classic, but then wanted to sell it again (as it wasn't the right size for him).
He, in turn, had acquired it two years earlier from a former Luccchinelli mechanic from Rimini, who had presumably built the bike. The motorbike was fitted with a 650cc Pantah engine and equipped with Pantah/ Allazzura wheels, forks and brakes.
As we felt the engine was not the right choice for the racetrack, we purchased a 1991 750SS with a more robust engine block and gearbox, as well as a dry clutch. Later, we acquired a second identical but even lower mileage engine (23, 000 km – this is currently fitted). The engine was fitted with Pantah 500 cylinder heads and the combustion chambers were modified accordingly.
Larger valves (43/ 38 mm) and camshafts from the 900 SSie were fitted, with significantly greater lift and improved timing. The ports and manifolds were adapted to the valve size. We fitted lightweight custom made forged MAHLE/ Wahl pistons with a higher compression ratio. This was complemented with 40 mm Dellorto carbs and an exhaust from twowheelclassics (UK). SR Racing (Lehnert) later supplied modified manifolds with improved flow and sealing. The entire engine was then tuned on the test bench. The focus was not on peak power but on torque, a broad rev range and durability, as we had aimed for endurance racing. This paid off: the bike can be ridden with very few gear changes and achieves excellent performance thanks to its low weight and extremely narrow silhouette.
We modified the drive ratio by fitting the primary drive from the Ducati ST2. A lighter flywheel (Kaemna -1100g) was fitted with updated sturdier pickup mounting. Ergal gears were used in the valve train. Rotating and oscillating masses were reduced > 2 kg in total.
The Pantah fork was replaced by a much sturdier 38mm Marzocchi fork from the Ducati Mike Hailwood Replica Mille, sourced from old stocks of new parts. This complied with SPA Classics regulations and allowed the fitting of 280mm brake discs without the need for an adapter. The fork’s internals were replaced with cartridges built by HH Racetech, adjustable for rebound and compression. On the Wilbers shock absorber, the spring was replaced.
The narrow Pantah rims were replaced with extremely lightweight Marvic Replica magnesium rims in sizes 2. 50 x 18 and 3. 50 x 18. The fixed Pantah cast brake discs were replaced with fully floating 280 mm discs.
Spa Classics regulations only allow two-piston calipers, so we initially went for P8 Oro calipers. During the most recent track day, we tested four-piston calipers from the Ducati 916 with an adapter and a radial brake master cylinder, which naturally improved braking performance considerably once again. Both configurations are available. The rear brake pull rod is from Leoncini.
To improve rideability, offset footrests and a seat riser were fitted. Over time, four different sets of clip-on handlebars were tried until we found a configuration that was easy on the arms and minimised fatigue.
The bike has a polished aluminium fuel tank with foam blocks.
The electrical system is based on a stripped-down 750SS wiring harness, upgraded with AMP connectors. A LiFePo battery is fitted. The highly reliable and programmable Ignitech ignition is complemented by Beru ignition coils from the Ducati Monster with dual ignition.
Weight approx. 135 kg.
The bike has been ridden a total of 8 or 9 times at Classic Trackday events. On one occasion, we took part in a 4-hour endurance race at ART-Motor in Oschersleben and secured 3rd place in our class straight away.
For health reasons, we are now unable to ride the bike and are offering it for sale. The bike is a pure racing machine and has no road registration documents.
Included are the sales contract from the previous owner and a vehicle registration certificate from the German ADMV Classic Cup.
Optional:
- 2nd engine from 1991 with dry clutch, 40, 000 km (original cylinder heads).
- Pantah 650 engine with approx. 20, 000 km odo
- Original Verlicchi aluminium box-section swingarm

More details and more pictures upon request...

Vehicle background

Has the vehicle ever been imported?

Yes

Is there any outstanding finance?

No

Has the vehicle ever been declared a total loss?

No

Has there ever been any major structural issues which needed work?

No

Private seller

1 listing since 2026
+4976170779467

Vehicle location

Freiburg im Breisgau, Freiburg, Germany
Get directions

Advert Details

Advert type:
For Sale
Category:
Motorcycles
Country:
Germany
Reference number:
C2236484
Listed on:
16/11/2026
Make:
Ducati
Year:
1982
Colour:
Red
Seller type:
Private

Gallery

Spotted an issue?

Get a valuation in minutes

Get a valuation in minutes

Fast and free, we provide accurate valuations you can trust. There's no obligation, and you might be pleasantly surprised.

Similar

Check out our new listings and upcoming auctions by subscribing to our newsletter

By signing up you accept our privacy policy and conditions of purchase