Description
1990 BMW E30 M52B28 Road Legal Track car
Dolphin grey
Mot April '23
122k on the clock
In the last 6 months it's had a rebuilt head, with new valve stem seals, gaskets, head bolts etc. motul 10w60 oil and filter
Fresh antifreeze
ksport 6 pot brakes with pagid rs29 pads
Fresh brake fluid ATE Type 200
Eibach arbs, drop links and D bush brackets.
Geo setup
Spec as follows:
Engine:
m52b28 with 112k fitted
Custom remap
M50 intake manifold with mishimoto elbow
Oem maf
New cam and crankshaft sensors
New 82 degree thermostat
New alloy thermostat housing with digital temp gauge and boss welded
New alloy water pump
New rocker cover gasket
New ngk plugs
New drive belt
New e34 throttle cable with copper bushings
Custom e34 shallow/ widened sump and pickup for ground clearance without losing any capacity with welded oil pump nut and boss welded for digital temp gauge
Bm conversions modded exhaust manifolds and downpipe ceramic coated in black with Ashley rear section and box
Drivetrain:
M42 318is gearbox blasted and painted with fresh oil June 2021
New luk clutch kit
7kg lightened m20 single mass flywheel
New slave and master cylinders
New gear selector rod
Quick shifter
Custom shortened e30 325i propshaft
3. 64 e30 LSD with new bearings and a refresh by heasman differential in October 2020 (probably about 5k miles) speedo sensor replaced and oil changed June 2021 (probably 2k miles)
Braking -
Custom brake backing plates and ducting entering in front bumper
Clio brake booster
Most brake lines have been remade and all flexi hoses have been replaced within the last 2 years
Suspension & handling -
Gaz gold collovers with adjustable top mounts, repainted with custom spring rates, helper springs and front top mount skf bearings in January 2021
Front and rear spacers
Front bolt on strut brace
T45 weld in strut brace between rear struts with reinforcement plates on turrets
T45 weld in brace between both front frame rails in front of rad
Bolt in rear cage
Interior -
Stripped, no carpets, rear seats, heaters, radio or any other creature comforts
Corbeau revenge large drivers seat with mount bolted to floor (new in august 2020)
4 point schroth harness drivers side
Flocked dash
Custom card on dash panel with volt meter, digital oil temp gauge, digital coolant temp gauge, ctek battery health indicator and a USB port
Carbon heater blanks fitted at both sides with the driver side having reverse lights on a switch and the passenger side having a battery cut off switch not yet wired in
Exterior and styling -
Full carbon double skin bonnet on aero catches - approx 3. 5kg
E30 m3 rear boot spoiler
Light weight abs motorsport 1 piece mtech 2 front bumper fitted on sliders and pins for quick release - lower metal valance all cut away with cold air intake to fog light blank and brake ducts to either side
Front plate Velcro'd on with holes cut behind it for additional cooling when needed
15x7j rimstock wheels wrapped in Michelin pilot sport 3's all straight.
Front bumper has stone chips. Few scuffs and dings as to be expected around the car but a good straight solid shell.
During my ownership it has wanted for nothing and has always been warmed up before being driven and religiously ran on Tesco 99. This is a truly brilliant, well set up car that has also been featured in Performance BMW magazine with its own 4 page spread. I will be very sad to see this go but I simply just don’t get time to use it and wanting to start my own business this year.
May be open to a p/ x
£12000 Ono
