Description
2006 DAX Tojeiro AC Cobra Replica -4, 800 Miles - £54, 950 (First to see will buy)
Professionally built by Southside Concepts in Woolwich to showcase their craftsmanship - this is not your average kit car. Southside are well-regarded in both the TV and kit car industries, and it shows in the detail and quality throughout this build.
This is a correctly registered 2006 DAX Cobra with only 4, 800 miles from new, built using all new parts and loaded with top-tier components.
Engine & Drivetrain
Ford 351 Windsor (5. 7L) V8 Turn-Key from The Engine Factory (USA)
Built with premium components (see full spec below)
Minimum output: 400BHP
Tremec TKO 600 5-Speed Manual gearbox (new at build)
Balanced aluminium flywheel & carbon clutch
Jaguar 2. 88:1 rear axle – perfect cruising gear ratios
Mcleod Series 500 clutch/ fork bearing/ master cylinder replaced less than 500 miles ago (£2K+ job)
Chassis & Suspension
DAX De Dion chassis - first powder-coated, then painted silver clear-over-base (stunning finish underneath)
Coil-over suspension
Fully painted chassis
2x 10" electric cooling fans
Exterior
Stunning colour-shifting paint: deep green/ black base with hints of blue, purple, and bronze/ copper in changing light. Looks black most of the time though, until the sun shines.
Stainless steel trim & exterior details
Stored indoors and rarely driven - paint and bodywork are 10/ 10
Interior
Professionally trimmed by Alan Povey in two-tone tan & green leather
Green Wilton carpets piped in tan leather (matching boot)
Fitted fire extinguisher in boot
Includes mohair roof and side screens, stored neatly in the boot
Additional Information
Correctly registered as a 2006 Dax Cobra
Just 4, 800 miles from new
A true turn-key car - ready to show, cruise or just admire
A few areas of light surface rust underneath (common for the age), but nothing structural or requiring immediate attention
Engine Build Specification (The Engine Factory)
Precision-machined Ford 351W block
Nodular crankshaft (micro-polished & deburred)
Shot-peened connecting rods w/ ARP bolts
Hypereutectic pistons (9. 7:1 compression)
Speed Pro rings & roller timing chain
Comp Cams hydraulic roller camshaft
Edelbrock RPM aluminium heads (60cc chambers)
Stainless swirl polished valves (intake & exhaust)
Magnum roller rockers (1. 6 ratio)
Melling oil pump, chrome sump, timing cover, and more
Pertronix ignition, Edelbrock intake & 650 CFM carb
March polished pulleys, 100A alternator, new fuel & water pump
Balanced, blueprinted, and hot-run tested before shipping
Price: £54, 950
FIRST TO SEE WILL BUY
If you're looking for one of the cleanest, lowest mileage, and most professionally-built DAX Cobras available today, this is it.
Based in LN5, Lincolnshire.
Viewings by appointment. Serious enquiries only, please. Professionally Built by Southside Concepts to showcase their craftsmanship — not a DIY build.
The Correct and most desirable Ford V8 Engine – 351ci Ford Windsor built by The Engine Factory (USA), pushing 400+ BHP.
Tremec TKO 600 5-Speed Manual
DAX De Dion Chassis - widely regarded as one of the best-handling Cobra replicas out there.
Show-Stopping Paintwork - One of One custom colour-shifting finish with deep green, blue, purple and copper tones.
Luxury Interior - professionally trimmed in two-tone leather with Wilton carpets and detailed piping.
4, 800 Miles from New - barely run in, incredibly clean throughout.
Correctly Registered as a 2006 Cobra - no kit car or Q plate registration headaches
Ready to Drive - recent clutch and master cylinder replacement (£2K+), turn-key condition.
Looks as Good Underneath as it Does on Top - painted and powder-coated chassis.
All the Right Parts - Edelbrock, Comp Cams, March, Pertronix, Samco, Roadcraft…
Perfect Mix of Performance & Presence – whether for shows, Sunday drives, or weekend blasts.
